Sunday, February 07, 2016

Automatic Ni-Cd Charger

Simple Ni-Cd charger (Automatic)

Simple Ni-Cd charger schematic

The charger has the following specs and characteristic:
1. Simple and minimal parts thus good for beginners and hobbyist.
2. Can be used to charge Ni-Cd of different voltages (2.4V, 3.6V, 7.2V, and other battery voltage)
3. Automatic with battery over-voltage protection. Current limited and voltage controlled.
4. Visual led indicator. Charging (red) and full-charge (yellow) indicator.

Part List Automatic Ni-Cd Charger Circuit :

R1 - 1.2 kilo ohms 1/4W
R2 - see R2 and D2 table below
R3 - 2 kilo ohms 1/4W
Q1 - TIP41C or any NPN transistor min 1A current and 3W power
Q2 - 2N2222, CS9013, or similar NPN transistor
LED1 - Red or any LED with forward voltage around 2V (see LED)
LED2 - yellow or any LED color except Red
D1 - 1N4001 or similar diode
D2 - see R2 and D2 table below
DC supply - 12V to 15V DC supply or battery
Read more at http://www.simple-electronics.com/2011/10/simple-ni-cd-charger-automatic.html#6KweD0rXTTDz4zSE.99

Electronic Circuit is a good site for hobbyist also who would like to try DIY because it shared good circuits. If you have a personalized circuit requirement you may feel free to request it through the comment box or contact me.