Skip to content Skip to sidebar Skip to footer

TDA2030 Power Amplifier Complete Tone Control

At this time I present a circuit of power amplifiers that use IC TDA2030, but this circuit is equipped with a tone control. Tone controls include Bass, Treble, and Volume. Power amplifier and tone control has been put together in a single PCB.

TDA2030 complete tone control

As well as its power supply circuit was also used as one with the power amp, and tone control. Making it easier in the installation and will look neat.

TDA2030 complete tone control Circuit Diagram
TDA2030 complete tone control Circuit Diagram
Layout PCB TDA2030 complete tone control
Layout PCB TDA2030 complete tone control

PCB design TDA2030 complete tone control
PCB design TDA2030 complete tone control

This amplifier is a mono amplifier type, can be modified for guitar amplifiers. If not coupled amplifier (mic preamp) then you must deactivated potensio treble and bass, why? because if not using a mic preamp and still maintain potensio treble and bass sound input (input) from the guitar will not or the maximum discharge is not tight on the speakers. So you must deactivated a way to decide which directly connected capacitor with the tone control circuit, and capacitor were connected directly to potensio volume and input jack.

2 comments for "TDA2030 Power Amplifier Complete Tone Control"

  1. What value capacitors for the rectifier!?

  2. 4700 uf 50 volt capacitors for the rectifier