Make a Digital Amplifier with PAM8610 Module

PAM8610 Amplifier Module

PAM8610 2x15W Stereo Digital Amplifier is a high-quality audio amplifier module that uses PAM8160 chip which can produce very clear sound and strong stereo separation.

Specifications:

Working voltage: 7V - 15V.

Output 2 stereo channel 2x10W (8Ohm) or 2x15W (4Ohm).

Output power: 10w + 10w (8 load)

Efficiency: 90%

Shutdown Current: 4uA

Quiescent current: 20mA

SNR: 86%

Total harmonic distortion: 5W / 1KHz / 8 ---- 0.1%

Frequency range: 20Hz-20KHz

Input impedance: 15K

Output Impedance: 4-8 Ohm

Dimensions: 30mm x 25mm x 2.5mm

Protection: Over Load, Over Temperature, Anti Popup Protection.

Material Specifications:

Using the chip from the latest DIODES INC PAM8610,

Using SMD components of high precision resistors, with tolerance of + - 1% 3. Layout of multi layer PCB with separate ground plane to ensure high S / N ratio, and low noise level.

PCB using Fiberglass material with thickness 1.6 mm, double-sided board.

The best quality PCB material

Using capacitor power type Low impedance more dynamic sound.

I made a power amplifier using this PAM8610 module using components not with high quality, the components I use as follows:

The first part of the power supply I use Switching Power Supply Unit with a 12volt DC output voltage ampere rating 1Amper, actual amperage rating that much less able to raise a voice of power amplifier PAM8610. I add a digital voltmeter to monitor the supply voltage. Then for the speakers use 2parts 3 Inch Speaker with 10W 4Ohm load power and also 2 pieces of tweter.

For volume settings and audio inputs use a stereo potentiometer and an additional RCA input jack. Power Amplifier using PAM8610 Class D.

I provide video in Indonesian version, following video build and test amplifier use PAM8610 Module.