Skip to content Skip to sidebar Skip to footer

Increase Regulator Voltage Output

It is often necessary to arrange an voltage regulator IC to give a higher output voltage than that set by the regulator alone. One method to achieve this is by connecting the “common” terminal to the mid-point of a potential divider but the problem with this method is that IC regulators have a small quiescent current (~10mA) flowing out of the common terminal to ground.

The magnitude of this quiescent current is not closely controlled and hence the total output voltage becomes somewhat unpredictable. Low divider resistor values help, but there are likely to be complications of heat dissipation and inefficiency.

Increase Regulator Voltage Output

24V from 12V regulator circuit diagram


The circuit presented here avoids the problem by using the transistor T1 to generate a low impedance at the regulator common terminal by emitter-follow action, while transferring the voltage divider from a relatively high-resistance divider network. The value of R3 is not critical but must be low enough to accept the highest quiescent current without causing T1 to turn-off.

1 comment for "Increase Regulator Voltage Output"

  1. ңave ƴou eveг thouǥht aboսt including a
    little bit mοre than just youг articles? I mеan, ԝhat ƴou
    say is valuable and all. Nеvertheless imagine if you ɑdded some grеat visuals օr videos to give
    yօur posts mοre, "pop"! Youг content is excellent ƅut
    ԝith images ɑnd video clips, this site could Ԁefinitely be one of the
    bеst in its field. Superb blog!

    my weblog - Real Estate

    ReplyDelete