Thursday, February 11, 2016

Simple Dew sensor circuit

This is a simple and low cost dew sensor circuit that can be used to switch off any gadget automatically in case of excessive humidity. Dew (condensed moisture) adversely affects the normal performance of sensitive electronic devices.

Dew sensor circuit
click view larger:Simple Dew sensor circuit

Dew (condensed moisture) 

The main part of this circuit is a low cost dew sensor element (resistor type). Although dew sensor elements are widely used in video cassette players and recorders, these may not be easily available in local market. However, the same can be procured from authorised service centres of reputed companies. The author used the dew sensor for FUNAI VCP model No. V.I.P. 3000A (Part No:6808-08-04, reference no. 336) in his prototype. In practice, it is observed that all dew sensors available for video application possess the same electrical characteristics irrespective of their physical shape/size, and hence are interchangeable and can be used in this project.

Use  dual op-amp IC LM358N 

This simple and low cost dew sensor circuit is basically a switching type circuit made with the help of a popular dual op-amp IC LM358N which is configured here as a comparator. (Note that only one half of the IC is used here.) Under normal conditions, resistance of the dew sensor is low (1 Kohm or so) and thus the voltage at its non-inverting terminal (pin 3) is low compared to that at its inverting input (pin 2) terminal. The corresponding output of the comparator (at pin 1) is accordingly low and thus nothing happens in the circuit.

When humidity exceeds 80%, the sensor resistance increases rapidly. As a result, the non-inverting pin becomes more positive than the inverting pin. This will push up the output of IC1 to a high level. As a consequence, the LED inside the optocoupler is energised. At the same time LED1 provides a visual indication. The optocoupler can be used to any electronic device for switching purpose.
This circuit uses a low voltage, low current power supply unit. The diode D1, resistors R8 and R6 and capacitor C1 do the job. This simple power supply module obviates the requirement for a bulky and expensive step down transformer.

Electronic Circuit is a good site for hobbyist also who would like to try DIY because it shared good circuits. If you have a personalized circuit requirement you may feel free to request it through the comment box or contact me.


EmoticonEmoticon